There are ways to solve the problem of stone engraving machine

1. Noise occurs when the stone engraving machine is running.

The usual reason is that there is a problem inside the motor of the stone engraving machine. At this time, the machine should be sent to the manufacturer for repair or the motor should be replaced directly.

2. The motor of the engraving machine is hot.

The reason for this situation is that there is a problem with the heat dissipation system of the stone engraving machine. It is recommended to check whether the pump is abnormal and whether the circulating water is lower than the liquid level, and then perform corresponding treatment.

3. The motor of the engraving machine is reversed.

At this time, the staff should check the motor line. If it is caused by the lack of phase of the motor line, it is necessary to change the output UVW end in time.

4. The motor speed of the engraving machine is very slow.

The biggest reason is that the motor power of the engraving machine is not normal. At this time, it is recommended that you check the cable connecting the stone engraving machine to see if it is short-circuited.